QUESTION 24
You confirm that the R2 and R3 routers are receiving a BGP route to the 203.0.113.0/24 network, but both routers display the route as hidden. Referring to the exhibit, which two actions solve this problem? (Choose two.)

QUESTION 25
You have recently configured MSTP on two switches in your network to participate in the same MSTP region. You issue the show spanning-tree mstp configuration command on both switches and notice that the configuration digests do not match.
What does this mismatch indicate?

QUESTION 26
Click the Exhibit button.

You have applied the policy shown in the exhibit to the forwarding table on an MX Series device.
How is traffic load-balanced?

QUESTION 27
Click the Exhibit.

Referring to the configuration in the exhibit, which two statements are true? (Choose two.)

QUESTION 28
Click the Exhibit.

You have configured the IBGP group shown in the exhibit. However, committing your configuration fails.
Which parameter should you add to the IBGP group configuration to correct the problem?

QUESTION 29
You are adding an IPv6 configuration to an Interface on a Junos device.
In this scenario, which statement is correct?

QUESTION 30
Which two statements are true about IP and GRE tunnels? (Choose two.)

QUESTION 31
Click the Exhibit button.

You are configuring an IBGP group. When you commit your configuration, you receive the error shown in the exhibit.
Which additional configuration parameter must you add to your configuration?

QUESTION 32
You have configured graceful RE switchover (GRES), however you cannot complete the show system switchover command.
Referring to the exhibit, what is the problem?

QUESTION 33
Click the Exhibit.

Referring to the configuration in the exhibit, which statement is true?

QUESTION 34
Click the Exhibit button. Referring to the exhibit, what must be true of the vlan_100 bridge domain?

QUESTION 35
Referring to the exhibit, which statement is true about VRRP?

QUESTION 36
In your network, you have two LDP routers connected across four physical interfaces. You have also enabled LDP to operate on all four of those interfaces. What is the resulting outcome of your configuration between those two routers?

QUESTION 37
By default, which three criteria are used by the Junos load-balancing algorithm to determine a traffic flow? (Choose three.)

QUESTION 38
Click the Exhibit.

Your router has an external peering session to 10.10.25.5 and several internal peers. However, routes learned from EBGP peers are showing up in a hidden state on IBGP peers.
Where would you apply the policy shown in the exhibit to solve this issue?

QUESTION 39
Which three statements are true about BGP? (Choose three)

QUESTION 40
Which two statements ate correct about the actions taken as the packet traverses the service provider MPLS network from Site 1 to Site 2 as shown in the exhibit?
(Choose two.)

QUESTION 41
Exhibit

Referring to the exhibit, which statement is true about VRRP?

QUESTION 42
Click the Exhibit.


Referring to the exhibit, which statement is correct about MVRP?

QUESTION 43
Exhibit button

Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)

QUESTION 44
Which type of router can provide connectivity between areas in an IS-IS domain?

QUESTION 45
The LSP is not establishing correctly.
Referring to the exhibit, what should you do to solve the problem?

QUESTION 46
You are asked to configure an LSP which uses the OSPF link state database for path computations. Which two statements are correct in this scenario? (Choose two.)

QUESTION 47
Click the Exhibit button.

Referring to the exhibit, which statement is correct?