Q41. A customer wants to enable wired authentication across all their CX switches One of the requirements is that the switch must be able to authenticate a single computer connected through a VoIP phone.
Which feature should be enabled to support this requirement?

Q42. A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. The legacy devices are connected to Aruba CX 6300 switches throughout the campus.
Which technology minimizes flooding so the legacy application can work efficiently?

Q43. What is true regarding 802.11k?

Q44. What is the order of operations tor Key Management service for a wireless client roaming from AP1 to AP2?

Q45. A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in place to prevent this device from connecting to the network again.
Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device? (Select two.)

Q46. You need to ensure that voice traffic sent through an ArubaOS-CX switch arrives with minimal latency What is the best scheduling technology to use for this task?

Q47. Which statement best describes QoS?

Q48. Which statements are true about VSX LAG? (Select two.)

Q49. A company deployed Dynamic Segmentation with their CX switches and Gateways After performing a security audit on their network, they discovered that the tunnels built between the CX switch and the Aruba Gateway are not encrypted. The company is concerned that bad actors could try to insert spoofed messages on the Gateway to disrupt communications or obtain information about the network.
Which action must the administrator perform to address this situation?

Q50. You are setting up a customer’s 15 headless loT devices that do not support 802.1X. What should you use?

Q51. Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?

Q52. A customer is looking Tor a wireless authentication solution for all of their loT devices that meet the following requirements
– The wireless traffic between the IoT devices and the Access Points must be encrypted
– Unique passphrase per device
– Use fingerprint information to perform role-based access
Which solutions will address the customer’s requirements? (Select two.)

Q53. You are deploying a bonded 40 MHz wide channel What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?

Q54. What are the requirements to ensure that WMM is working effectively’? (Select two)

Q55. Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device The following configuration was created on the switch:

Q56. Match the terms below to their characteristics (Options may be used more than once or not at all.)

Q57. What is a primary benefit of BSS coloring?

Q58. With the Aruba CX switch configuration, what is the first-hop protocol feature that is used for VSX L3 gateway as per Aruba recommendation?

Q59. What is enabled by LLDP-MED? (Select two.)

Q60. The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message is being sent to the AOS-CX switch.
An administrator has performed the following configuration

What is the most likely cause of this issue?