Verified NSE7_SDW-6.4 Exam Dumps PDF [2023] Access using TestKingIT [Q43-Q66]

By adminOn February 10, 2023

4/5 - (1 vote)

Verified NSE7_SDW-6.4 Exam Dumps PDF [2023] Access using TestKingIT

Try Best NSE7_SDW-6.4 Exam Questions from Training Expert TestKingIT

Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:

Topic	Details
Topic 1	Centrally manage an SD-WAN infrastructure from FortiManager Configure basic SD-WAN setup
Topic 2	Configure SD-WAN rules Troubleshoot VPN and ADVPN
Topic 3	Configure SD-WAN routing SD-WAN troubleshooting
Topic 4	Troubleshoot central management problems Troubleshoot SD-WAN

NEW QUESTION 43
Which three parameters are available to configure SD-WAN rules? (Choose three.)

Application signatures

Type of physical link connection

URL categories

Source and destination IP address

Internet service database (ISDB) address object

NEW QUESTION 44
Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)

Specify a unique peer ID for each dial-up VPN interface.

Use different proposals are used between the interfaces.

Configure the IKE mode to be aggressive mode.

Use unique Diffie Hellman groups on each VPN interface.

NEW QUESTION 45
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

The FortiGate cloud key has not been added to the FortiGate cloud portal.

FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

The zero-touch provisioning process has completed internally, behind FortiGate.

FortiGate has obtained a configuration from the platform template in FortiGate cloud.

A factory reset performed on FortiGate.

NEW QUESTION 46
Refer to the exhibit.

Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)

The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.

The number of simultaneous connections among all source IP addresses can exceed 5 connections.

The number of simultaneous connections allowed for each source IP address can exceed 5 connections.

The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

NEW QUESTION 47
Refer to the exhibit. Which conclusion about the packet debug flow output is correct?

The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.

The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.

The packet size exceeded the outgoing interface MTU.

The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.

NEW QUESTION 48
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )

It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance

It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links

It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub

It provides direct connectivity between all sites by creating on-demand tunnels between spokes.

NEW QUESTION 49
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?

The shaper mode must be applied per-IP shaper on the traffic shaping policy

The application control profile must be enabled on the firewall policy.

The web filter profile must be enabled on the firewall policy

The URL category must be specified on the traffic shaping policy

NEW QUESTION 50
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )

It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.

It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.

It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.

NEW QUESTION 51
Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? <Choose two )

There are separate virtual interfaces for each dial-up client.

VPN static routes are prevented from populating the FortiGate routing table.

FortiGate created a single IPsec virtual interface that is shared by all clients.

100.64.3.1 is one of the remote IP address that comes through index interface 1.

NEW QUESTION 52
Refer to the exhibit.

Which statement about the command route-tag in the SD-WAN rule is true?

It enables the SD-WAN rule to load balance and assign traffic with a route tag

It tags each route and references the tag in the routing table.

It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.

It ensures route tags match the SD-WAN rule based on the rule order

NEW QUESTION 53
Refer to exhibits.

Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

The reverse shaper option must be enabled and a traffic shaper must be selected

The guaranteed-10mbps option must be selected as the reverse shaper option.

A new firewall policy must be created and SD-WAN must be selected as the incoming interface.

The guaranteed-10mbps option must be selected as the per-IP shaper option

NEW QUESTION 54
Refer to the exhibit

Based on the exhibit, which two statements about existing sessions on FortiGate after a firewall policy change, are true?(Choose two.)

The old sessions terminate after a policy change

Existing sessions remain unchanged after a policy change

All sessions are flushed by FortiGate after a policy change

FortiGate re-evaluates new packets after a policy change

NEW QUESTION 55
Which diagnostic command can you use to show interface-specific SLA logs for the last 10 minutes?

diagnose sys sdwan log

diagnose sys sdwan health-check

diagnose sys sdwan intf-sla-log

diagnose sys sdwan sla-log

NEW QUESTION 56
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

Set priority 10.

Set cost 15.

Set load-balance-mode source-ip-ip-based.

Set source 100.64.1.1.

NEW QUESTION 57
Which statement about using BGP routes in SD-WAN is true?

Adding static routes must be enabled on all ADVPN interfaces.

VPN topologies must be form using only BGP dynamic routing with SD-WAN

Learned routes can be used as dynamic destinations in SD-WAN rules

Dynamic routing protocols can be used only with non-encrypted traffic

NEW QUESTION 58
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

Traffic has matched none of the FortiGate policy routes.

Matched traffic failed RPF and was caught by the rule.

The FIB lookup resolved interface was the SD-WAN interface.

An absolute SD-WAN rule was defined and matched traffic.

NEW QUESTION 59
Refer to the exhibit.

Based on the exhibit, which status description is correct?

Port1 is dead because it does not meet the SLA target.

Port2 is alive because its packet loss is lower than 10%.

The SD-WAN members are monitored by different performance SLAs.

Traffic matching the SD-WAN rule is steered through port2.

NEW QUESTION 60
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)

SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom

The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces

The implicit rule overrides all other rules because parameters widely cover sources and destinations.

The initial session of an application goes through a learning phase in order to apply the correct rule

NEW QUESTION 61
Refer to exhibits.
Exhibit A.

Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output Based on the exhibits, which statement is correct?

Both SD-WAN member interfaces have used separate SLA targets.

The SLA state of port1 is dead after five unanswered requests by the SLA servers.

Port1 became dead 1ecause no traffic was offload through the egress of port1.

SD-WAN member interfaces are affected by the SLA state of the inactive interface

NEW QUESTION 62
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

The dead member interface stays unavailable until an administrator manually brings the interface back.

The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

Port2 needs to wait 500 milliseconds to change the status from alive to dead.

Check interval is the time to wait before a packet sent by a member interface considered as lost.

NEW QUESTION 63
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?

FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.

Each IP is guaranteed a minimum 10 Mbps of bandwidth

A single user uses the allocated bandwidth divided by total number of users.

The 10 Mbps bandwidth is shared equally among the IP addresses.

NEW QUESTION 64
Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? <Choose two )

There are separate virtual interfaces for each dial-up client.

VPN static routes are prevented from populating the FortiGate routing table.

FortiGate created a single IPsec virtual interface that is shared by all clients.

100.64.3.1 is one of the remote IP address that comes through index interface 1.

NEW QUESTION 65
Refer to exhibits.

Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)

All the existing sessions that do not use SNAT will be flushed and routed through port1.

All the existing sessions will continue to use port2, and new sessions will use port1.

All the existing sessions using SNAT will be flushed and routed through port1.

All the existing sessions will be blocked from using port1 and port2.

NEW QUESTION 66
Why is it effective to use SD WAN rules when configuring application control?

Because traffic can be load balanced based on application type

Because SD-WAIM rules are independent from firewall policies to avoid controlling applications

Because you must use certificate full inspection on the firewall policy

Because the application database is manually maintained by administrators

Latest 100% Passing Guarantee – Brilliant NSE7_SDW-6.4 Exam Questions PDF: https://www.testkingit.com/Fortinet/latest-NSE7_SDW-6.4-exam-dumps.html

Verified NSE7_SDW-6.4 Exam Dumps PDF [2023] Access using TestKingIT [Q43-Q66]

Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:

Leave a Reply Cancel reply