QUESTION 10
Drag and drop the characteristics from the left onto the correct functionalities on the right.

QUESTION 11
An engineer must perform an assessment of a customer LAN for a future IEEE 802.11ac Wave 2 wireless deployment All access switches are Fast Ethernet-Capable only, and the wired infrastructure between existing APs and access switches is based on the CAT 6A standard. Which two actions provide maximum support of Cisco 3800 Series access points? (Choose two.)

QUESTION 12
A network administrator of a global organization is collapsing all controllers to a single cluster located in central Europe. Which concern must addressed?

QUESTION 13
Which statement about the 9800 Series Wireless Controller mobility tunnel on a Cisco Catalyst 9800 controller is true?

QUESTION 14
A network engineer needs to create a wireless design wired IP surveillance cameras in the parking lot through a mesh AP. To which operate mode of the AP should the cameras connect?

QUESTION 15
A customer has determined that aesthetics is a primary concern for their upcoming guest deployment. Which design consideration can be leveraged to address this concern?

QUESTION 16
An engineer must ensure that the new wireless LAN deployment can support seamless roaming between access points using a standard based on an amendment to the 802.11 protocol. Which protocol must the engineer selects?

QUESTION 17
A wireless engineer is hired to design a network for a technology company. The company campus has four buildings and a warehouse with access points that provide full wireless coverage as well as a pair of WLCs located in the core of the network. Which type of wireless architecture is being used?

QUESTION 18
Campus users report a poor wireless experience An engineer investigating the issue notices that in high-density areas the wireless clients fail to switch the AP to which are automatically connected This sticky client behavior is causing roaming issues Which feature must the engineer configure?

QUESTION 19
Refer to the exhibit. On the basis of the output of the show spanning- tree inconsistentports command, which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true?

QUESTION 20
An engineer has deployed a group of APs in an auditorium and notices that the APs are showing high co- channel interference. Which profile can be used to adjust the parameters for these high-density APs?

QUESTION 21
Which three pieces of equipment are needed to conduct a fully measured wireless survey? (Choose three.)

QUESTION 22
Which three pieces of equipment are needed to conduct a fully measured wireless survey? (Choose three.)

QUESTION 23
A wireless engineer is using Ekahau site survey to validate that an existing wireless network is operating as expected, which type of survey should be using to identify the end-to-end network performance?

QUESTION 24
An engineer is designing a wireless network to support nigh availability. The network will need to support the total number of APs and client SSO. Live services should continue to work without interruption during the failover. Which two requirements need to be incorporated into the design to meet these needs? (Choose two)

QUESTION 25

Refer to the exhibit. A client roams between two APs that are registered to two different controllers, where each controller has an interface in the client subnet. Both controllers are running AireOS. Which scenario explains the client roaming behavior?

QUESTION 26
A high-density wireless network is designed. Which Cisco WLC configuration setting must be incorporated in the design to encourage clients to use the 5 GHz spectrum?

QUESTION 27
A company wants to replace its existing PBX system with a new VoIP System that will include wireless IP phones. The CIO has concerns about whether the company’s existing wireless network can support the new system. Which tool in Cisco Prime can help ensure that the current network will support the new phone system?

QUESTION 28
A wireless engineer is hired to design a network for a technology company. The company campus has four buildings and a warehouse with access points that provide full wireless coverage as well as a pair of WLCs located in the core of the network. Which type of wireless architecture is being used?

QUESTION 29
A company has 10 access point licenses available on their backup Cisco WLC and their primary Cisco WLC is at full capacity, 5 access points are set to high failover priority and 7 access points are set to critical failover priority. During a failure, not all critical access points failed over to the backup Cisco WLC. Which configuration is the cause of this issue?