NO.84 What is the minimum inside bend radius for balanced twisted pair (4 pair) cable?

NO.85 Which of the following makes the biggest impression on a customer when you are communicating via email?

NO.86 Light pulses in optical fiber cables are subjected to a loss in power as the light pulses travel along the optical fiber. Which of the following terms is used to describe this phenomenon?

NO.87 When installing optical fiber cable in a cable tray with a 15 cm (6 in) inside depth, which of the following support practices is MOST appropriate to adhere to bend radius requirements?

NO.88 Which of the following should be used to install plywood in a telecommunications room if the edge of the board does NOT align with the wall studs?

NO.89 You are terminating a category 3 cable. What is the maximum permissible amount of untwisting?

NO.90 According to BICSI guidelines, which of the following best describes the maximum pulling tension recommended for a 4-pair UTP cable during installation (without using special pulling grips)?

NO.91 Which of the following must be measured before the length of a coaxial cable can be calculated?

NO.92 Electrical power (P) is measured in ___________?

NO.93 Which of the following is used to equalize potential differences between the SBB on the same floor?

NO.94 A radio station transmits an omnidirectional signal that is received by multiple radios. What type of transmission method is used in this example?

NO.95 For a telecommunications grounding and bonding system, which bonding conductor is typically responsible for ensuring that all metallic pathways and equipment within a building’s telecommunications spaces are at the same ground potential?

NO.96 When labeling patch panels, which of the following is MOST aligned with TIA-606 and BICSI best practices?

NO.97 Under TIA-568 requirements, which performance parameter is crucial for a Permanent Link but NOT measured for a basic wire map test?

NO.98 Which is a keyed, contact, moderate loss connector in present use today that is pull & wiggle-proof?

NO.99 Which of the following is the bonding connection point for telecommunications systems and equipment in the area by a telecommunication space?

NO.100 A BICSI Installer 2 must verify continuity on all conductors of a multi-pair backbone copper cable. Which tool is the MOST efficient for accomplishing this?

NO.101 Which type of cabling is installed between a main cross connect and a horizontal cross connect?

NO.102 Which of the following is a benefit of air-blown optical fiber cable?

NO.103 Which of the following is designed to provide protection from harmful chemicals?

NO.104 Which of the following testing parameters is REQUIRED for Category 6A balanced twisted-pair cabling to verify compliance with TIA standards during certification testing?

NO.105 Which of the following describes a situation where a BICSI Installer 2 may have to calculate a cable’s derating factor?

NO.106 How much cable slack should be left in the work area after termination?

NO.107 Which type of tester includes a set of modular plugs?