350-401 Certification – Valid Exam Dumps Questions Study Guide! (Updated 507 Questions) [Q302-Q325]

By adminOn May 12, 2022

4.8/5 - (14 votes)

350-401 Certification – Valid Exam Dumps Questions Study Guide! (Updated 507 Questions)

350-401 Dumps are Available for Instant Access using TestKingIT

Exam topics

You should know that Cisco 350-401 covers six different topics and each has its specific components. The percentage associated with each of them informs the weight that each objective has in the questions. This means that the sections with the higher percentages will likely have more questions than those with lower figures. The domains covered in this test are highlighted below:

Infrastructure: 30%;
Network Assurance: 10%.
Architecture: 15%;
Security: 20%;

Let’s look at these 6 topic areas that are covered in the 350-401 certification exam and explore their special aspects in detail.

NEW QUESTION 302
Why would an engineer use YANG?

to transport data between a controller and a network device

to access data using SNMP

to model data for NETCONF

to translate JSON into an equivalent XML syntax

NEW QUESTION 303
Which statement explains why Type 1 hypervisor is considered more efficient than Type 2 hypervisor?

Type 1 hypervisor runs directly on the physical hardware of the host machine without relying on the underlying OS.

Type 1 hypervisor enables other operating systems to run on it.

Type 1 hypervisor relics on the existing OS of the host machine to access CPU, memory, storage, and network resources.

Type 1 hypervisor is the only type of hypervisor that supports hardware acceleration techniques.

NEW QUESTION 304
Refer to the exhibit.

How does the router handle traffic after the CoPP policy is configured on the router?

Traffic coming to R1 that does not match access list SNMP is dropped.

Traffic coming to R1 that matches access list SNMP is policed.

Traffic passing through R1 that matches access list SNMP is policed.

Traffic generated by R1 that matches access list SNMP is policed.

NEW QUESTION 305
Drag and drop the snippets onto the blanks within the code to construct a script that shows all logging that occurred on the appliance from Sunday until 9:00 p.m Thursday Not all options are used.

NEW QUESTION 306
If a client’s radio device receives a signal strength of -67 dBm and the noise floor is -85 dBm, what is the SNR value?

15 dB

16 dB

18 dB

20 dB

NEW QUESTION 307
The login method is configured on the VTY lines of a router with these parameters The first method for authentication it TACACS If TACACS is unavailable login is allowed without any provided credentials Which configuration accomplishes this task?

Option A

Option B

Option C

Option D

NEW QUESTION 308
Refer to the exhibit. Which troubleshooting a routing issue, an engineer issues a ping from S1 to S2. When two actions from the initial value of the TTL? (Choose two.)

The packet reaches R3, and the TTL expires

R2 replies with a TTL exceeded message

R3 replies with a TTL exceeded message.

The packet reaches R2 and the TTL expires

R1 replies with a TTL exceeded message

The packet reaches R1 and the TTL expires.

NEW QUESTION 309
Refer to the exhibit.

An engineer attempts to create a configuration to allow the Blue VRF to leak into the global routing table, but the configuration does not function as expected. Which action resolves this issue?

Change the access-list destination mask to a wildcard.

Change the source network that Is specified in access-list 101.

Change the route-map configuration to VRF_BLUE.

Change the access-list number in the route map

NEW QUESTION 310
Refer to the exhibit.

Which configuration must be applied to the HQ router to set up a GRE tunnel between the HQ and BR routers?

Option A

Option B

Option C

Option D

NEW QUESTION 311
Drag and drop the LISP components from the left onto the function they perform on the right. Not all options are used.

NEW QUESTION 312
An engineer is concerned with the deployment of a new application that is sensitive to inter-packet delay variance. Which command configures the router to be the destination of jitter measurements?

Router(config)# ip sla responder udp-connect 172.29.139.134 5000

Router(config)# ip sla responder tcp-connect 172.29.139.134 5000

Router(config)# ip sla responder udp-echo 172.29.139.134 5000

Router(config)# ip sla responder tcp-echo 172.29.139.134 5000

NEW QUESTION 313
Refer to the exhibit.

An engineer must establish eBGP peering between router R3 and router R4. Both routers should use their loopback interfaces as the BGP router ID. Which configuration set accomplishes this task?

R3(config)#router bgp 200
R3(config-router)#neighbor 10.4.4.4 remote-as 100
R3(config-router)# neighbor 10.4.4.4 update-source Loopback0
R4(config)#router bgp 100
R4(config-router)#neighbor 10.3.3.3 remote-as 200
R4(config-router)#network 10.3.3.3 update-source Loopback0

R3(config)#router bgp 200
R3(config-router)#neighbor 10.24.24.4 remote-as 100
R3(config-router)#neighbor 10.24.24.4 update-source Loopback0
R4(config)#router bgp 100
R4(config-router)#neighbor 10.24.24.3 remote-as 200
R4(config-router)#neighbor 10.24.24.3 update-source Loopback0

R3(config)#router bgp 200
R3(config-router)#neighbor 10.4.4.4 remote-as 100
R3(config-router)#bgp router-id 10.3.3.3
R4(config)#router bgp 100
R4(config-router)#neighbor 10.3.3.3 remote-as 200
R4(config-router)#bgp router-id 10.4.4.4

R3(config)#router bgp 200
R3(config-router)#neighbor 10.24.24.4 remote-as 100
R3(config-router)#bgp router-id 10.3.3.3
R4(config)#router bgp 100
R4(config-router)#neighbor 10.24.24.3 remote-as 200
R4(config-router)#bgp router-id 10.4.4.4

NEW QUESTION 314
Drag and drop the virtual components from the left onto their deceptions on the right.

NEW QUESTION 315
Refer to the exhibit.

Which action resolves the EtherChannel issue between SW2 and SW3?

Configure switchport mode trunk on SW2.

Configure switchport nonegotiate on SW3

Configure channel-group 1 mode desirable on both interfaces.

Configure channel-group 1 mode active on both interfaces.

NEW QUESTION 316
Which statement about Cisco Express Forwarding is true?

It uses a fast cache that is maintained in a router data plane.

it maintains two tables in the data plane the FIB and adjacency table.

It makes forwarding decisions by a process that is scheduled through the IOS scheduler.

The CPU of a router becomes directly involved with packet-switching decisions.

NEW QUESTION 317
Drag and drop the descriptions from the left onto the QoS components on the right.

NEW QUESTION 318
Which characteristic distinguishes Ansible from Chef?

Ansible uses Ruby to manage configurations. Chef uses YAML to manage configurations.

The Ansible server can run on Linux, Unix or Windows. The Chef server must run on Linux or Unix.

Ansible pushes the configuration to the client. Chef client pulls the configuration from the server.

Ansible lacks redundancy support for the master server. Chef runs two masters in an active/active mode.

NEW QUESTION 319

Refer to the exhibit. PC-1 must access the web server on port 8080. To allow this traffic, which statement must be added to an access control list that is applied on SW2 port G0/0 in the inbound direction?

permit host 172.16.0.2 host 192.168.0.5 eq 8080

permit host 192.168.0.5 host 172.16.0.2 eq 8080

permit host 192.168.0.5 eq 8080 host 172.16.0.2

permit host 192.168.0.5 it 8080 host 172.16.0.2

NEW QUESTION 320
Refer to the exhibit.

SwitchC connects HR and Sales to the Core switch However, business needs require that no traffic from the Finance VLAN traverse this switch Which command meets this requirement?
A)

B)

C)

D)

Option A

Option B

Option C

Option D

NEW QUESTION 321
Drag and drop the LISP components from the left onto the function they perform on the right. Not all options are used.

NEW QUESTION 322
A network engineer is adding an additional 10Gps link to an exiting 2x10Gps LACP-based LAG to augment its capacity. Network standards require a bundle interface to be taken out of service if one of its member links goes down, and the new link must be added with minimal impact to the production network. Drag and drop the tasks that the engineer must perform from the left into the sequence on the right. Not all options are used.

NEW QUESTION 323
An engineer is working with the Cisco DNA Center API Drag and drop the methods from the left onto the actions that they are used for on the right.

NEW QUESTION 324
Which function does a fabric edge node perform in an SD-Access deployment?

Connects the SD-Access fabric to another fabric or external Layer 3 networks

Connects endpoints to the fabric and forwards their traffic

Provides reachability border nodes in the fabric underlay

Encapsulates end-user data traffic into LISP.

NEW QUESTION 325
Refer to the exhibit.

An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to
10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthemet 0/1.
Which configuration commands can the engineer use to allow this traffic without disrupting existing traffic flows?
A)

B)

C)

D)