QUESTION 43
Refer to the exhibits.

Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the receiver.
The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives one reply packet through T_INET_1_0.
Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)

QUESTION 44
Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit A shows an SD-WAN event log and exhibit B shows the member status and the SD-WAN rule configuration.
Based on the exhibits, which two statements are correct? (Choose two.)

QUESTION 45
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?

QUESTION 46
Which two interfaces are considered overlay links? (Choose two.)

QUESTION 47
The SD-WAN overlay template helps to prepare SD-WAN deployments. To complete the tasks performed by the SD-WAN overlay template, the administrator must perform some post-run tasks. What are three mandatory post-run tasks that must be performed? (Choose three.)

QUESTION 48
Refer to the exhibit.

Based on the output, which two conclusions are true? (Choose two.)

QUESTION 49
Which diagnostic command can you use to show the member utilization statistics measured by performance
SLAs for the last 10 minutes?

QUESTION 50
Refer to the exhibit.

In a dual-hub hub-and-spoke SD-WAN deployment, which is a benefit of disabling the anti-replay setting on the hubs?

QUESTION 51
Refer to the exhibit.

The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?

QUESTION 52
Refer to the exhibit.

Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change?
(Choose two.)

QUESTION 53
What are two common use cases for remote internet access (RIA)? (Choose two.)

QUESTION 54
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process?
(Choose two.)

QUESTION 55
Refer to the exhibit.

Which statement explains the output shown in the exhibit?

QUESTION 56
What are two benefits of choosing packet duplication over FEC for data loss correction on noisy links?
(Choose two.)

QUESTION 57
What are two advantages of using an IPsec recommended template to configure an IPsec tunnel in a
hub-and-spoke topology? (Choose two.)

QUESTION 58
The administrator uses the FortiManager SD-WAN overlay template to prepare an SD-WAN deployment. With information provided through the SD-WAN overlay template wizard, FortiManager creates templates ready to install on spoke and hub devices.
Select three templates created by the SD-WAN overlay template for a spoke device. (Choose three.)

QUESTION 59
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

QUESTION 60
Which statement about SD-WAN zones is true?

QUESTION 61
Refer to the exhibit.

Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?

QUESTION 62
Refer to the exhibit.

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2.
Which two configuration settings are required for Toronto and London spokes to establish an ADVPN shortcut? (Choose two.)

QUESTION 63
Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit A shows an SD-WAN event log and exhibit B shows the member status and the SD-WAN rule configuration.
Based on the exhibits, which two statements are correct? (Choose two.)